China Fabric Factory Fabric News Maintenance and management of shuttleless loom temple device

Maintenance and management of shuttleless loom temple device



Maintenance and management of shuttleless loom temple device 1. Maintenance 1. Installation and operation inspection The anti-rust oil needs to be removed from the shuttleless loom…

Maintenance and management of shuttleless loom temple device

1. Maintenance
1. Installation and operation inspection
The anti-rust oil needs to be removed from the shuttleless loom side support device before installation, and the thorn tips should be checked for bruises, bends, and barbs. Copper thorn rings, Whether the polyurethane ring, rubber roller, and steel licker-in rotate sensitively. If there is any problem, it should be repaired or replaced. During installation, check whether the left and right side supports are installed incorrectly, whether the box cover touches the side supports and thorns, and whether the nuts are tightened.
2. Patrol inspection
During the patrol inspection, if the operator discovers problems such as side support defects, chipped edges and broken edge yarns, he should immediately notify the mechanic to inspect and replace the side support device and gussets. During the fabric width inspection, if narrow width, uneven tension on the left and right fabric edges and defects on the fabric edges are found, the temple device should be further checked or the position of the temple box should be adjusted.
3. Routine maintenance
If the thorn tips of the copper thorn ring are worn, they need to be replaced. If some of the thorn tips are bent or barbed, the bad steel needle can be removed and a new steel needle can be replaced in the original position. If the copper thorn ring The nylon bushing of the polyurethane ring is worn, causing the gap to increase. The same type of nylon bushing can be purchased and replaced. The rubber roller and steel licker-in roller bushings need to be replaced after wear.
2. Warehouse Management
(1) After purchasing the shuttleless loom side support device, it should be inspected or randomly inspected for acceptance one by one, and placed separately according to the variety and specifications to avoid picking up the wrong ones during use.
(2) Pay attention to the stacking order, adhere to the principle of first-in-first-out, do not make the storage time too long, and check the quality every six months.
(3) After refurbishing the temple supports and copper thorn rings that have been renovated or rotated out of use, distinguish the left and right hands, apply anti-rust oil, wrap them in oil paper, and indicate the specifications and models on the In the box, copper thorn rings should not be stacked too much in each box. They should be handled with care to avoid damaging the thorn tips.
AAAGFHTRYKUYIU7OUP

Extendedreading:https://www.yingjietex.com/product/Full-dull-Nylon-Twill-Taslon-Breathable-Fabric.html
Extendedreading:
Extendedreading:
Extendedreading:
Extendedreading:
Extendedreading:
Extendedreading:
Extendedreading:
Extendedreading:
Extendedread

This article is from the Internet, does not represent 【www.factory-fabric.com】 position, reproduced please specify the source.https://www.factory-fabric.com/archives/32967

Author: clsrich

 
TOP
Home
News
Product
Application
Search